Installing a pool heater is not a tough thing.
When you bought an INVERBOOST pool heat pump, indeed that is a good decision. You are going to enjoy efficient savings and comfortable temperatures the whole year, what you need to do is install it. Installing a Pool Heater is a manageable task, but you need to know the relevant expertise and knowledge, you want the new heat pump to keep an efficient and long life, and your installation must get all state and local codes.
You must want to find heat pump installers near me, please read the below article first. This detailed guide will tell you how you can plan, manage and install your INVERBOOST pool heat pump, especially choosing the perfect position and how to prepare, plan, and set up your pool heater install, what is more, the common mistakes you need to avoid. Ready to get to know heat pump installation? Follow me!
Choose a good location for your heat pump
The best place to put the INVERBOOST UX heat pump is outdoors with clean surroundings because they require air circulation on the ground near a pool filter or pump in a place with restricted airflow is preferable.
One of the most important factors to consider after getting your pool heater is looking for the perfect installation location. the best place to install your pump is a spacious outdoor spot-particularly on that has direct exposure to ultralight.
The base of the heater for a pool should be flat irrespective of whether it’s below or above water level, you can put your heater on a concrete base, a very small timber decking section, or some paving slabs set on the sand. Because the pool heat pump generates minimal vibrations, it is hard to disturb your slabs.
For further upgrades and servicing endeavors, always make sure that enough space around your pool heaters for easy access.
Setting Preparation for Installing a pool heater
Depending on your pool heater size and weight, there is also a need to allocate a large base to place your pump. You can decide to have one made of plinth or consolidate a solid concrete. Ensure your heater’s stand is not fixated in your house since heat pumps tend to render vibrations and disturbing noises. Your pool heaters could be equipped with a filter pad.
To make sure there are proper air circulations around your pool heater, always expose it to open surroundings away from walls or any form of shade. This maintains its full functioning capacities. Be careful with roof drainage and gutters, so you don’t end up setting your heat pump anywhere close to them since during heavy rains, it may suffer damage from dropping water.
With power suitably in place and minimal plumbing, your installation process should only take a few hours to finish. If you are beginning from scratch, although you can do it yourself, it is often faster, safer and best to hire a professional worker to install your heat pump to make sure it is done properly and complies with all codes and warranty terms.
In the end, once your wärmepumpe für pool is installed, you can enjoy comfortable pool temperatures in the four seasons.
The heat pump must also be properly earthed
As the pool heater is outdoors located, the electrical circuit should also be protected by an RCD. Most pool heat pumps have a single-phase electrical supply. 3-phase electrical supply is normally only found on larger properties or on commercial Installing a Pool Heater. If you are not sure, if you have a one-phase electrical supply or not, ask the pool heater installation near me electrician to confirm this for you.3 TIPS for Installing a Pool Heater